C9 Pixel String Rec...
 
Notifications
Clear all

C9 Pixel String Recommendations

11 Posts
6 Users
0 Reactions
2,367 Views
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
K-State Fan wrote:I have had pixabulbs from diyledexpress and have not had any issues. This is season 6 with them.

Plus 1 here - I like Pixabulbs (3 years no failures)

also, buy addition strand(s) so if you replace a dead bulb, it will match.


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
MikeKrebs wrote: The usual advice is to replace two pixels. The last one and the first wonky.

The last one in the string or the last good one before the wonky one. I'm curious why replace a good one?


Reply
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago
MichiganLights wrote:The I'm curious why replace a good one?

Typically the "last on one" receives the data, turns on but doesn't send the data forward therefore next one (and the rest) are off. So in other words, the last one one isn't functioning 100%. I do the same as what Mike said. Actually had to do this yesterday.


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago

What is your preferred voltage for Pixel strings?

I assume 12V is preferred to 5V pixels so you can run smaller gauge wire? Any other considerations?


Reply
Posts: 113
(@cmndr-brain)
Estimable Member
Joined: 9 years ago
stressed out suspense

Reply
Page 2 / 3
Share: