Not to the controller itself, just put resistors between the output terminals and the pixel extension wires
OregonLights wrote:Not to the controller itself, just put resistors between the output terminals and the pixel extension wires
I don't believe this will fix my issue. I can successfully run over 20ft from controller to the first pixel. My issue is when when there is a gap more than 5ft between pixels/elements.
Matter of fact, I have a 25ft cable from one output to a string of 170 pixels. The biggest gap between pixels is 12". I have no issues in this example.
James
Phrog30 wrote:I don't believe this will fix my issue. I can successfully run over 20ft from controller to the first pixel. My issue is when when there is a gap more than 5ft between pixels/elements.Matter of fact, I have a 25ft cable from one output to a string of 170 pixels. The biggest gap between pixels is 12". I have no issues in this example.
James
Each Ws2811 chip is a repeater. Your controller could have a strong transmit line but your pixels have weak retransmit....or you may have a single pixel at the end of the first window, or first pixel is weak at second Window - or something in between. Can you reverse the Windows - feed window 2 to window 1 - what are the results
I did try reversing windows, no change. On my eaves, which had no issue, I added a 10 ft cord in between two sections. I started having issues.
Before I added a null pixel I wanted to try cat5/6 cable. I made a 15 ft cable (just wire nut together) and this works. I'm only sending data, since I'm feeding the 2nd window power already.
So, I guess it's the kind of cable I was using. It's interesting because I'm using this cable all over the place, including the runs from controller to first pixel and have no problems, except when I'm connecting in the middle.
James
Phrog30 wrote:We probably had the same issue. If I shorten the cable between elements to 5 feet, no problem. However, I can't go this short because my windows are about 10 ft apart.I'm going to try null pixels first.
Thanks for all of the help.
James
Sounds like it. I thought about doing the null pixel, but with this my first year I didn't realize I didn't have to use a "null" in the sense of the PixLite. I now realize I could have just put a pixel inline and accounted for it in the setup, but don't light it up.
My issue was where I was power injecting and had the 3rd line coming off of the tee. The data wasn't feeding anything, but caused the loss in signal. I needed up just pulling out the 3rd pin from the tees. I could have also had custom tees made.
I ordered a few of these.
http://falconchristmas.com/forum/index.php/topic,2115.0.html
Travis
Sent from my iPhone using Tapatalk
