I have 10 strings of 60 pixel icicle lights on my roof from Ray. They're ws2811 12v
The layout on the Lft roof is 3 sets (180pixels), center 4sets(240pixels) and Rt roof 3 sets (180pixels).
At the moment they're set 120 pixels per universe at 360 channels. This gives me 5 universes for the entire roof. They go to a Falcon F16V3 and are on one port on virtual strings for a total of 600 pixels.
They are power injected every 120 pixels.
The issue is they work fine if they are all lit at one time any color or if they're twinkled, if I wipe them across the house the last string in each section (the 3rd lft & RT and 4th in the center) either doesn't light or lights a few seconds late but all on not the variation of a wipe.
When I put vertical bars across the house they always light only one color for the entire 3rd string.( 4th on the center)but the first 2 or 3 strings show normal moving bars.
What is the best way to set up the 10 sets ? Is it better to use higher universe counts or separate them into universes of 60 pixels each? Or maybe split the strings to 2 ports?
I welcome any discussion, Thanks!
I've been working on this since the last post so here's the update.
Added 2more power injection points, and split the pixels to 2 ports on the falcon F16v3.
Change the universe count to 180 (60 pixels 1string) per universe, added 5 universes to each of the two ports.
I decided to run directly from my laptop to check the Falcon Pi Player and make it easier to make small changes and check the results.
Made a small test sequence with mostly wipes because they seem to be the biggest problem. Unpatched all the roof pixels and re-patched without zig-zag, no change,
changed settings to horizontal orientation, some improvement but still no change on the wipe, changed the wipe from count to pulse which seems to help on long intervals but not on short sweeps from left to right or right to left.
Changed the intensity level to a 0-100 ramp , no change, also checked the patching order ,no change. I'm running out of idea's , I cannot seem to get wipes to work with the icicle pixels.
During a wipe the first 2 sets of pixels on the lft , center and right work as expected but the last set on the lft , right and center do not light then when they should but light after the wipe is complete and full on no wipe.
All the other effects like on, twinkle, bars, alternating, dissolve etc. all work fine.
If anyone has the same pixel icicle lights from Ray please let me know how you set them up!
Adding universes that are partly full wastes network bandwidth and adds no functionality to the display. The falcon player does not care about the arrangement of the universes and provides a mapping mechanism that makes such division a waste of effort.
The issue you are experiencing is caused by the way your elements are set up in the preview. A Wipe uses "location" in the preview to determine when the lights change color. You also need to make sure there is a bit of time in the effect at the end to see the color or add a layer with the target color to take over when the effect finishes.
MartinMueller2003 wrote:Adding universes that are partly full wastes network bandwidth and adds no functionality to the display. ......
That right there is an awesome tip!
Martin, Thanks for clearing up the universe issue for me that makes sense. I can change them back to use less universe space.
Like I said in the post I made a small sequence with varied duration of wipes and other effects up to about 15 seconds long and had no change in the results of the wipe just longer off time. Maybe I'm not quite understanding your answer but I thought it was a duration problem but it acts like it's out of sequence and skipping sections and then catching up, which was why I thought the correct signal wasn't reaching the specific lights in time. It's difficult to explain in words what I'm seeing so I took a video last night but didn't have time to upload it .
I'll try to post it tonight.
