I am helping a neighbor with some HDPE arches he built using WS2811 12v pixel strips. We had them running and tested in his garage a couple months ago all working. We deployed them out in the yard and now out of the 12 arches we have out there half of them at least are stuck on just red. That's either sending data to the pixels or sitting there plugged in but no data being sent.
We're using one of Ron's Pi Hats for Pixels. It's configured correctly - was used in the testing of the pixels originally. The power supply is the same and I tested it at giving out about 11.94 volts. We have 12 arches with 51 pixels in each arch, 6 sets of arches plugged in to each of the two outputs on the Pi. Also using power injection.
He did have a problem using silicon that was conductive (I forgot to tell him to use the GE Silicone II) to seal things but that was corrected and all was working like I said a couple months ago when we tested it. We actually ran it all on one port with no problems too.
Any ideas why these strips would get stuck on red when powered on? Could it come errant silicon be left over firing this off?
I plan on switching the arches around a bit to see if it's one bad arch as I believe I remember seeing once one comes on red the rest in line come on red. Hard to recall exactly but that's my initial thought.
Thanks!
Jason
While not the same scenario, I have some issues with 5v pixels in my arches and tracked it down to a the power supply being plugged into a cord that had a bunch of 12v pixel power supplies on it. When I move the 5v to a different outlet they worked fine.
I know this is going to sound silly but I had almost the same issue and the fix was rather simple....
Out of the 4 arches, I had one arch that refused to be arch #1 no matter what I did. If it was the first plugged into controller, all arches would display white.
I moved that arch to position #3 and everything worked as it should. I figured it was a bad connection and moved it back....SAME THING.
I ended up labelling the arches and kept that one as #3 and all is good.
Weird but it works.
😉
You did not indicate where in the string the "Red" arches started. You also did not mention whether the arches after the first red one where all red. Please give us a bit more information about how the arches are wired and exactly where the issue starts.
Things to try: Move each non working arch to the start of the chain to verify the arch itself is functioning properly. With a working arch, replace the cable between the working arch and the controller with the cable from the first non working arch to see if the cable is giving you an issue. Remember to twist and move the wire around the connector to see if there is a poor contact.
Pixels use a consumptive protocol. The first bad pixel causes the rest of the pixels in the chain to not work as expected (and sometimes in very odd ways). To me what you are describing is a pixel gone bad or if the previous arch works and the next arch does not, a bad cable between the arches. Just because it worked in testing, does not mean it will work outside. The temperature is different, the humidity is different, the sun shines on them during the day, sometimes pixels just go bad.
