Address-able Pixel ...
 
Notifications
Clear all

Address-able Pixel Group

15 Posts
7 Users
0 Reactions
3,088 Views
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
[#56651]

I'm planing on 3D printing some large translucent or transparent Christmas light bulbs with pixels inside to light them up. The kind of props to line a walkway or driveway.

Is there such a thing as an addressable group say ~12 or so pixels? I want each bulb (multiple pixels) as a single address if possible (ESPixelStick).


14 Replies
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago

In Xlights you can set the Group count to 12, this will have all 12 pixels act as one. It'll be in the Controller Connection section of the model in the layout tab.


Reply
Posts: 418
(@richienorthcott)
Reputable Member
Joined: 7 years ago

There other option would be some custom electronics where you take a WS2811 IC and interface it to your multiple LEDs. This is tricky though, in particular since the ICs are surface mount devices and are teeny tiny. It's probably easier to do this in your authoring software as the previous post mentions, defining a group for your pixels. Both Xlights and Vixen support this concept. What is your reason for wanting this on three output channels only?

Is it due to limitations on the number of output channels available on ESPixelStick?

Another option would be to use DMX and 'dumb' LED controllers.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

or renard dc controllers connected to the esp


Reply
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago

You can also group the pixels in the controller itself in ESPixelStick...


Reply
Page 1 / 3
Share: