RichieNorthcottwrote:It's probably easier to do this in your authoring software as the previous post mentions, defining a group for your pixels. Both Xlights and Vixen support this concept. What is your reason for wanting this on three output channels only?
I'm not sure how many pixels its going to take get a single prop to glow bright enough. I wanted to avoid using up an entire universe for 30-40 of these props. Maybe I'm over thinking it.:zipped:
144 Renard SS Channels and Counting
Vixen 3
ESPixelStick V3
Random Pixels
Is the point of the 12 ws2811 leds just to be able to give the prop sufficient light to light it up ?
If that is what you want to to then just get 9 PCs leds like these I put an ebay link hope this helps.
mr fixwrote:Is the point of the 12 ws2811 leds just to be able to give the prop sufficient light to light it up ?
If that is what you want to to then just get 9 PCs leds like these I put an ebay link hope this helps.
They are these were an example if you use 2 ws2811 nodes you should have plenty if light to light up the prop don't think you need 12 and as mentioned in one of the other postes about grouping the pixels to as one.