Acceptable 12v volt...
 
Notifications
Clear all

Acceptable 12v voltage drop

11 Posts
7 Users
0 Reactions
4,462 Views
Posts: 212
Topic starter
(@myoung84)
Reputable Member
Joined: 12 years ago
[#47030]

I tried searching but can't come up with what I'm looking for. What's an acceptable voltage drop at the end of a pixel run? I've got two sets of 60 Ray Wu icicle lights connected together and I'm getting about 9.5v at the end of the last pixel when at 100% white. At 50% (set at F16) I'm up to about 10.5v. Other colors are over 11v. I don't plan on running them over 50%. I can power Inject, but didn't want to if I don't have to. At what voltage threshold is it required? I didn't see any color difference in first to last pixel or any flickering.

Sent from my SAMSUNG-SM-G935A using Tapatalk


10 Replies
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

In my opinion acceptable is that it still works. If you start seeing white turn to pink or erratic behavior then you have too much voltage drop. Most of the time you won't see much difference between 100% brightness and 70%, so you can usually get away with just lowering the brightness.

Sent from my Pixel using Tapatalk


Reply
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

This is definitely subjective to each person. If it looks fine to you that’s all that really matters.


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
myoung84 wrote:I tried searching but can't come up with what I'm looking for. What's an acceptable voltage drop at the end of a pixel run? I've got two sets of 60 Ray Wu icicle lights connected together and I'm getting about 9.5v at the end of the last pixel when at 100% white. At 50% (set at F16) I'm up to about 10.5v. Other colors are over 11v. I don't plan on running them over 50%. I can power Inject, but didn't want to if I don't have to. At what voltage threshold is it required? I didn't see any color difference in first to last pixel or any flickering.

Sent from my SAMSUNG-SM-G935A using Tapatalk

Check out this link: http://spikerlights.com/calcpower.aspx


Reply
Posts: 212
Topic starter
(@myoung84)
Reputable Member
Joined: 12 years ago

Thanks for the insight! I'll run them around 50% and keep an eye on potential issues.

Sent from my SAMSUNG-SM-G935A using Tapatalk


Reply
Page 1 / 3
Share: