5v WS2811 Power inj...
 
Notifications
Clear all

5v WS2811 Power injection

3 Posts
2 Users
0 Reactions
3,146 Views
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago
[#26188]

In the attached drawing, I have a representation of one side of a burst I have built. There will be an identical left side but I didn’t want to clutter up the drawing more than it already is.

I know I have to inject power to these pixels as denoted in the top picture. The reason for injecting every 25 pixels is, there is a 4 foot gap between pixels 25 and 26, 50 and 51, etc. The wire running between these pixels is 16 gauge, 3 conductor, SPT-2

My question is:
Should I add a ground wire to the negative side of the pixel wires too, (as denoted in the bottom drawing), or will the SPT-2 and the actual pixel ground wire suffice? If my understanding is correct, this would be a common ground. If that is not correct, could someone please explain what a common ground is

Thanks for any insight,
Ron


2 Replies
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

Your diagram will work. I know there's been some discussion on Facebook as well. For 25 pixels, it's not absolutely necessary to backfeed power to the "end" of the pixel string (i.e. pixel 25), so if all you want to connect to the end of the string is the data line, that would work.

As far as common ground, that's usually the "-" connection on the power supply. In order for the data to be interpreted by the pixels correctly, you need a common connection from the "-" terminal on the power supplies feeding the controller (like an E682) and any power supplies feeding power to the pixels.

To keep from having current flow between power supplies on the common or "ground" wire, otherwise known as "ground loops", it's usually good practice to keep all the power supplies close to each other and make these common connections between "-" terminals with as short a wire or cable as possible between the power supplies.

When feeding or injecting power, it's usually recommended to run both "+" and "-" to the point of injection. Folks need to be aware that if you plan to run a single set of wires back to the power supply, and then daisy-chain to the next power injection point, and so on..., you need to size the wire correctly so that it can handle the full load of ALL the power injection points, since the sum of the current will be flowing thru that single wire coming from the PS. If you run a wire from the PS to each power injection point, then you can use a wire sized for just the additional pixels. In your example, that would be 25 pixels worth of current.

Does that help?


Reply
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago

It does. Thanks for the explanation. That clears a bunch up. My drawing wasn't concise enough. I was planning on using a terminal block to run power from power supply to the block with 12 gauge stranded wire and then Zipcord from the terminal block to each arm. Of course, I'll need 2 or 4 depending on whether I use 1 block for positive and 1 block for negative, for all 10 arms or 1 each, + and - for 5 arms. The drawing was just so cluttered, I didn't do it the way it should have been drawn. I tried to un-clutter the attached drawing as much as I could, but I think this is what you're saying. (see attached)

Thanks again,
Ron


Reply
Share: