Notifications
Clear all

50 pixels

11 Posts
6 Users
0 Reactions
4,649 Views
Posts: 59
(@arange98)
Trusted Member
Joined: 12 years ago

Interested in exactly this setup. Is there a connection diagram somewhere?

Thanks!
Allen


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

https://www.adafruit.com/product/1787
https://cdn-shop.adafruit.com/product-files/1787/1787AHC125.pdf

This is the board I used, but any breadboard will do:
https://www.radioshack.com/collections/breadboards-ic-sockets/products/general-purpose-ic-pc-board

And a socket so you can replace the chip if unfortunate things happen:
https://www.radioshack.com/collections/breadboards-ic-sockets/products/14-pin-retention-contact

I used male/female jumper wires to connect to the GPIO pins. I soldered the male end to the breadboard and used the female end on the GPIO header.
https://www.adafruit.com/categories/469
If you are hanging this off a Raspberry Pi Zero, it has no header pins, so you want the male/male wires.

In my case, and the photos above, I was feeding 5v into the board from a 5v supply. Then back feeding it to the pi to power the pi. This is not recommended as it bypasses the crowbar protection on the Pi. Better to power the Pi through the USB port. 5V out of the pi is on the GPIO header as well and can power this chip. You can't power the pixels, any pixels direct from the Pi, it doesn't have a regulator sufficient to supply them.

Bring data and ground off this board to the pixels. Ground and power from your pixel PSU to the pixels. Pretty blinkies.

And if you are curious how portable this is or what I used it in.... here is a clue:

And here is the full on use:


Reply
Posts: 890
(@ben-bobbi)
Noble Member
Joined: 17 years ago

what did you use for a power supply that was not too heavy for her?


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago
ben&bobbi wrote:what did you use for a power supply that was not too heavy for her?

Drone batteries (LiPo).

Here is an internal walkthrough of the disco ball:


Reply
Posts: 20
(@loopy-froot)
Eminent Member
Joined: 10 years ago

Wolfie....you crafty bugger... that is amazeballs....{-- see what I did there.. heheh


Reply
Page 2 / 3
Share: