Im new to pixels this year. Im using xlights and e682 controllers. I have a mega tree with 36 strands with 22 pixels each and a star with 20 pixels. I am connecting 4 strands together up and down to use 9 outputs on the controller and then the star another output. I have the strands set up on xlights like they need to be but cant figure out how to program the controller to make it work. Any help would be appreciated!
Set the E682 up to reverse every 22 pixels.
Then for your 9 outputs, set them up so that the next output start where the previous one ends, PLUS one. So if the E682 tells you that e.g. 1-4 ends in Universe 1 channel 450, then make 2-1 start on Universe 1 channel 451 etc. This counts for all 9 strands.
Then tell Xlights you have a 36 x 22 megatree, with the starting channel being whatever the first pixel is of your first strand. If you use run-on addressing, you won't need to configure any other strands or ports.
deonb wrote:Set the E682 up to reverse every 22 pixels.Then for your 9 outputs, set them up so that the next output start where the previous one ends, PLUS one. So if the E682 tells you that e.g. 1-4 ends in Universe 1 channel 450, then make 2-1 start on Universe 1 channel 451 etc. This counts for all 9 strands.
Then tell Xlights you have a 36 x 22 megatree, with the starting channel being whatever the first pixel is of your first strand. If you use run-on addressing, you won't need to configure any other strands or ports.
Ive tried and still no luck. Here is my settings.


Sent from my iPhone using Tapatalk
pixel lengh setting is 22 you have nothing to zig or zag .
try it on the 88 pixels per output and you will see it work .
angus40 wrote:pixel lengh setting is 22 you have nothing to zig or zag .try it on the 88 pixels per output and you will see it work .
It was at 88 and tried it at 22 to see what would happen. The pixels work like they are sideways and not up and down a tree
Sent from my iPhone using Tapatalk
