2801 Pixel String C...
 
Notifications
Clear all

2801 Pixel String Color Consistency

5 Posts
5 Users
0 Reactions
2,396 Views
Davor
Posts: 221
Topic starter
(@davor)
Reputable Member
Joined: 16 years ago
[#22319]

I have 2801 and 2811 pixel strings and the 2801s has some pretty obvious inconsistencies in color when in all white. I know that manufacturers bin LEDs with a degree of tolerance, but the 2811s are much more consistent, even though they have more of a blue tint than the 2801s. When the 2801 strings are on white, some of them are a nice, warm, white but others are pinkish-white. However, when the 2801s are only on Red, Green, or Blue, the colors of each pixel all look the same. Is this normal for this type of LED used in these pixels? Or did I get a bad batch? Or is there something I need to tweak on my E681? I'm running firmware 2.025 and the pixel strings are plugged directly into the controller.


4 Replies
Donny M. Carter
Posts: 1008
(@donny-m-carter)
Noble Member
Joined: 16 years ago

Color inconsistency is possible. One thing to verify is power. You may need to inject power at the other end (from the same ps). Check the numbers and see what you have.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

This is normal - the pinkish colour is displayed on the pixels as the supply voltage drops. It will always be the pixels ferthest from the power supply. Basicly the cable being used for pixels is not realy thick enough.
There are 2 ways round this:
1. Reduce the intensity of white to 80% (this uses less power).
2. Feed more power into the string (some people are feeding power to both ends some just to the middle of the strip). You will find lots of post about injecting power to pixels.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Pinkish at the end of the string is low voltage as noted above. I'd do both suggestions, dial down intensity for this year and plan to inject power next year.

Sent from my SCH-I500 using Tapatalk 2


Reply
Posts: 353
(@bigredsoftware)
Reputable Member
Joined: 15 years ago

Adding power at the end balances things quite nicely. I was fortunate enough to read all those posts and test in summer to verify. I know there is a very calculable way to figure out the power requirements and voltage drop, but in the end adding connections back to the supply at the end of each string was the way to go.


Reply
Share: