Start Address Firmw...
 
Notifications
Clear all

Start Address Firmware

8 Posts
5 Users
0 Reactions
21.3 K Views
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

So I have been using this start address firmware for a few years at a neighbors house. I have 3 SS8 boards, with xbee. First board start address 1. Second board start address 9. Third board start address 17. Trying to add an SS24 with start address 25 with xbee. Xbee radio works with standard pic, but my start address pic is not working. Using a pickit software with the same programmer I have used in the past. I tried erasing the firmware, then loading the start address firmware, but I can't get it to work. Any ideas?

Using the simple renard tester to test outputs on the SS boards, and wireless control with the xbee.

My xbees are set up for 57600 baud, no parity, 1 stop bit.


Reply
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

Well, that was stupid. I think I figured it out. To start with channel 25, I need to use start address 3 correct?


Reply
dirknerkle
Posts: 10308
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Yes. The Wiki is your friend. For the 16F688 chip, use the formula in the guide:

http://www.doityourselfchristmas.com/wiki/index.php?title=Renard_Start_Address_Configuration_Guide


Reply
Page 2 / 2
Share: