Start Address Firmw...
 
Notifications
Clear all

Start Address Firmware

8 Posts
5 Users
0 Reactions
21.3 K Views
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago
[#44142]

If I want to make a Renard SS24 use the start address firmware, do I only need to load it into the first PIC?


7 Replies
Posts: 221
(@stenersonj)
Estimable Member
Joined: 17 years ago

if I recall correctly, it only needs to be in the first one.


Reply
Posts: 317
(@dvc2013)
Reputable Member
Joined: 14 years ago

If you are using start addressing it needs to be on the first PIC of each controller board.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago
dvc2013 wrote:If you are using start addressing it needs to be on the first PIC of each controller board.

That's true of the controllers are in parallel, or connected to different ports on the PC or whatever is driving the controllers. It doesn't need to be used if the controllers are in tandem.


Reply
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

Can someone send me the hex file for start address firmware, start address 25? I have tried to load the one I have and can't get it to work. I can't seem to remember how to get from the asm file to hex. I have MPLab x IDE. I did this years ago, and can't remember how to do it.

Thanks.


Reply
Page 1 / 2
Share: