Renard SS24 - Flash...
 
Notifications
Clear all

Renard SS24 - Flashed chips not working

18 Posts
6 Users
0 Reactions
22 K Views
robskimeister
Posts: 49
Topic starter
(@robskimeister)
Trusted Member
Joined: 12 years ago
will post more after this post

Part 2:

Pickit With Good Chip  Blank Check after Erase
Pickit With Good Chip   After Write
VPickit With Good Chip   Verification After Write
Pickit With Good Chip  Blank Check after Write & Verify Says BLANK!

Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago

My question is, why do you keep using the "blank check" feature? It has nothing to do with what you need accomplished.
At this point, you should pick up some new PICs and try.


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago

Okay... here is somethings I see.............

First, uncheck the MCLR and try a 4.9 voltage (copy my picture)

Second, In your "Source" box, I never see the firmware loaded. look at my step two pic.

After programming, stop, remove the pic, nothing else needs done.

step1
step2
step3

Reply
robskimeister
Posts: 49
Topic starter
(@robskimeister)
Trusted Member
Joined: 12 years ago

Thanks Wayne! It may be tomorrow before I can try again, but I'll try what you suggested.

...and I won't do a blank check! :wink2:


Reply
robskimeister
Posts: 49
Topic starter
(@robskimeister)
Trusted Member
Joined: 12 years ago

OK... Finally found time to try again. Success! :biggrin:

I guess the problem was my fault, but it's also due to the fact that the pickit software is NOT very intuitive / user friendly.

Here's what was happening...

I loaded the first chip (of 6). I performed an ERASE because I read that you should always do that first. Then I clicked FILE, IMPORT HEX, and selected the Renard hex file. The SOURCE box in the pickit software showed the hex file as expected. I flashed the chip, and it was successful.

Then I loaded the 2nd chip & performed an ERASE. However, the ERASE function caused the SOURCE box to become blank! ...and I didn't notice it when I flashed the chips in the past. Since I didn't notice, I proceeded to flash the remaining 5 chips with NOTHING! That's why I had 1 good chip, and 5 blank chips.

So when I re-flashed them today I had to re-import the hex file after erasing, and before writing each of the chips. What's up with that? Once I load a file, it should STAY THERE! That's just crappy software IMHO.

When I clicked ERASE, my intent was to erase THE CHIP, not the imported file! Very confusing! :excl:

Hopefully my experience will help other people who run into this issue & find this post.

Thanks again to all who helped!

I can't wait to see all the kids' smiling faces when the lights are shining brightly!:yeah:


Reply
Page 3 / 4
Share: