You did a "blank check"? That erases them. You only write the firmware and then use them.
I have the same programmer you have chip in right spot and notch does face the lever
Wayne J wrote:You did a "blank check"? That erases them. You only write the firmware and then use them.
OK... now I'm really confused.
I did a "blank check" on the 1 chip that's working, and the program said it was NOT blank. So I did NOT re-flash it, and it's still working. I just tested them all a few minutes ago.
I re-flashed the other 5, did a verify... and all was successful. I did NOT do a blank check. They're still not working. I assume they're blank (the first channel in that group of 8 stays on).
I'm out of ideas because I'm pretty sure I'm doing everything correctly.
The only thing I can come up with is bad chips. Why would 1 work, and 5 not... when I performed the exact same steps for all of them?
Gremlins!?
I have the same programmer you have chip in right spot and notch does face the lever
Thanks for that info... Glad to know it wasn't "user error"!
Try this.. take the one that is working, and re-flash it and try.
Wayne J wrote:Try this.. take the one that is working, and re-flash it and try.
Ok... tried that. Here are the steps I performed on the "good chip:
* Downloaded the Renard operational firmware again from here: http://doityourselfchristmas.com/wiki/index.php?title=Renard_SS24_Controller_Board#Firmware
* Used MPASMWIN to generate the hex file
* Plugged in the pickit2 programmer with the chip installed. The blue button on the pickit was in the UP position (UP is for 8-20 pin chips; DOWN is for 28-40 pin chips)
* Opened the pickit2 software; the pickit was detected
* Performed BLANK CHECK - Was NOT blank
* Performed ERASE
* Performed WRITE - Successful
* Performed VERIFY - Successful
* Performed BLANK CHECK - Chip is BLANK
* Tested chip - Now this chip does NOT work (Channel 1 stays on; the other 7 channels don't work)
Hopefully someone has an idea of what may be happening, because I don't.
Do I have a bad pickit?
I've attached 5 screenshots of the steps I mentioned above (limit of 5 per post; will post more after this post). Maybe there's something on the screens that may give a clue as to what's happening.
Thanks again for any help or ideas anyone may have.
