probability a simple fix but I am in a bind.
I have a SS16 and a PX1 I am trying to get on the same 485 cable. I have my ss16 first on the network and then the PX1 next. The ss16 works at the 57k. Per the wiki thew PX1 only works on the 115k. I need to change the SS16 to 115K, so they both will work on the same 485.
I have Pickit 2. I can read the chips. Can someone point out where on the Pickit2 screen I need to change the SS16 from 57K to 115K?
Thanks!!
I could be wrong but i am pretty sure use just need to update the following line in the firmware to the baud rate you are going to use:
#define BAUDRATE 57600
You will need to recomplie and then write to the chip.
.asm file is here if you need it:
http://www.doityourselfchristmas.com/wiki/index.php?title=Renard_Firmware
Only running 12 Pixifloods on the px1, to wash the house, so 32 channels for 12 10W floods.
ANGERMGT wrote:Only running 12 Pixifloods on the px1, to wash the house, so 32 channels for 12 10W floods.
Actually, 36 channels (12 x 3) for the pixafloods. You can run the PX-1's at 57,600, but you get twice as many pixels at the higher baud rate. The 115,200 is the default for the PX1, but either way, the baud rates need to match if they are daisy chained.

