Renard Pixel String
 
Notifications
Clear all

Renard Pixel String

62 Posts
16 Users
0 Reactions
32.9 K Views
Posts: 84
Topic starter
(@cypress1138)
Trusted Member
Joined: 18 years ago
n1ist wrote:A few notes on the schematic:
- 12v in goes to a net labeled "+24"
- The LEDs are all backwards
- There's a large rectangle that cuts through components on the bottom of the schematic
- I would add 100n decoupling caps on U3 and U4
- I would tie U4p1 high or pull it up
- RN1 is not needed

/mike

Thank you for pointing out all the problems in the schematic. I have changed this up so many times I count it as a small miracle that anything makes sense anymore! I will make the changes tonight and repost it tomorrow. The large rectangle is a mystery but I think that when I "printed" the schematic Acrobat added the rectangle for some reason.

ErnieHorning wrote:RN1 is not needed because it's done internally by the software.

Oh yeah internal pull up resistors...duh!!!

See if it wasn't for you guys I guarantee I would have released the factory smoke!


Reply
Posts: 84
Topic starter
(@cypress1138)
Trusted Member
Joined: 18 years ago

Since this project has moved over to DMX control the project thread is moving as well and is called the DMX Pixel String (I know impressive original name ;-)) and it can be found here.

Thank you all for your help!!


Reply
Page 13 / 13
Share: