Ren48LSDv3c pic pro...
 
Notifications
Clear all

Ren48LSDv3c pic programing problems?????

17 Posts
4 Users
0 Reactions
6,472 Views
Posts: 17
Topic starter
(@ted19020)
Eminent Member
Joined: 15 years ago
[#20383]

I need some guidance in this task, after 4 -5 hours of chasing my tail I will call in the Calvery. On page 29 Under Programming the Pic controllers-
Renard protocol: It states that A standard version of the codewith the above settings has been compiled already for you in the File Library advailable here ( http://doityourselfchristmas.com/forums/dynamics/attachments.php?attachmentid=207&d=1280420686).This is my first Renard48LSD build and I ran into a wall on the programming, all of my voltages have checked out good and this is the next step. What am I doing wrong. I have already programmed PIC's for a ren 24 ss & 4 ren 8 ss withno problem.
Thanks in advance
ted19020


16 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You didn't indicate which version you needed but both the Renard/Serial and Renard/DMX versions can be found at http://doityourselfchristmas.com/forums/dynamics/showentry.php?e=97&catid=6 in the File Library. Just download whichever version you need and flash all 6 PICs with the same code.


Reply
Posts: 17
Topic starter
(@ted19020)
Eminent Member
Joined: 15 years ago

Thankyou, budude, within a short time after reading your post I had my pic's flashed and installed on the board but the voltage reading between pins 2 and 14 only reads 0.58 to 0.61. I have checked and rechecked all of my joints and orientations, the oscillator voltage between upper left and lower right is 4.99v. I will now reflash the pic's and try again.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I would ignore that reading for now and just try running some lights on the outputs and see what happens.


Reply
Posts: 15
(@madane)
Active Member
Joined: 19 years ago

Hi to all ,

I have just now assembled Renard48LSD with ULN2803 for the moment i am using only one PIC16F688 programmed for test drive i am not able to get any output to the ULN2803 connecting a led with resistor on the output pin of PIC16f688 the led light stable . Please kindly give infomation for this;

Thanking you in advance
Madane


Reply
Page 1 / 4
Share: