Programmer for rena...
 
Notifications
Clear all

Programmer for renard ss24 board

10 Posts
5 Users
0 Reactions
5,037 Views
Posts: 49
Topic starter
(@brad2157)
Trusted Member
Joined: 18 years ago

So after looking for a male to female serial cable at Target, Wal-Mart, Best Buy, Electronic Express, and K-Mart...I finally found one at Radio Shack. Came home tonight, hooked it up. Followed the video's for dl'ing the .asm and converting it to .hex, and flashed the pics with winpic800. HOORAY!!!!! Sucess at last! Thank you so much for the advice to just use my JDM. I was ready to give up and order a pickit3, wait for it to come in, and then try it out. I was tickled to death to create a very basic sequence in vixen and it actually work on my lights hooked up. I am happier than a kid in a candy store:D:D


Reply
RichF
Posts: 1356
(@richf)
Noble Member
Joined: 19 years ago

congratulations!


Reply
Posts: 80
(@mj-ferry)
Trusted Member
Joined: 18 years ago

no problem , thats great that you got your pics programmed and have it working.I have used a cheapo programmer for all of my programming without a problem so far.

Michael:):):cool:


Reply
Posts: 11
(@nickgarc)
Active Member
Joined: 16 years ago

the programmer was one thing i overlooked in this whole process. any advice on one i can get real quick? i have 9 chips needed to be programmed?


Reply
Posts: 1
(@neiljohnson)
New Member
Joined: 17 years ago

Try the pickit1 I Have a renard ss24 and 5 renard ss8's, all chips were programed using the pickit1. It is available direct from Microchip for $36. It is also a good platform for learning the basics of PIC processors.


Reply
Page 2 / 2
Share: