Programmer for rena...
 
Notifications
Clear all

Programmer for renard ss24 board

10 Posts
5 Users
0 Reactions
5,036 Views
Posts: 49
Topic starter
(@brad2157)
Trusted Member
Joined: 18 years ago
[#13050]

Is this all I should need to program the PICS for my renard SS24 board?

http://cgi.ebay.com/ICSP-Adapter-ZIF-8-14-w-PICkit-3-USB-Programmer-/230432427613?pt=LH_DefaultDomain_0&hash=item35a6d7ce5d

I am new to this, bought my board and components last year, soldered them up and was hoping to get going for this years display, but I drug my feet until the last minute. I am stuck at the part of programming the pics. I first bought the JDM cheap-o programmer and found out it won't work with MPLABS software or with WINPIC800 using the USB-serial adapter I bought for my PC.


9 Replies
Posts: 80
(@mj-ferry)
Trusted Member
Joined: 18 years ago

Do you not a have a serial port at all on your pc? I have one of the clone jdms and I have programmed alot of pics with it using winpic800, it just wont work with usb to serial adapters.


Reply
Posts: 49
Topic starter
(@brad2157)
Trusted Member
Joined: 18 years ago

I am using a old PC and it does have a serial port on the back. When I ordered my serial cable though, it is a male to male cable and I need a male to female to be able to hook the JDM. I had picked up the serial to USB adapter today, in hope that if I ever change PC's, I could still be able to use the programmer.

How hard is it to use WINPIC800 instead of MPLABS to program the PICS?


Reply
Posts: 80
(@mj-ferry)
Trusted Member
Joined: 18 years ago

All I do to use winpic800 is open it select com port , programmer type , open file and program chip.


Reply
Posts: 49
Topic starter
(@brad2157)
Trusted Member
Joined: 18 years ago

Thanks, I was in a rush to try to get this going last minute. Now since I have ran into several little problems, I am just going to take my time and make sure it is ready for next years display. I am going to go try to find the correct serial cable I need today (male to female) and will see if I can get these pics programmed.

Thanks for your help mj ferry!


Reply
Page 1 / 2
Share: