Pickit2 problems
 
Notifications
Clear all

Pickit2 problems

16 Posts
8 Users
0 Reactions
22.2 K Views
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

I think I finally got it! SORT OF! Yesterday I was looking at the PICKIT2 software and decided well I might as well try to reload the software for the PICKIT2. That's when I saw the hex file. I figured what the hell. I loaded that to the PICKIT2 thinking "it's not going to work because that hex file is probably for me to program a chip if I wanted to create a programmer later",and VIOLA she's a working. (Now I sit here hitting my head against a wall saying DOH!!!! ) I had to change the voltage in MPLAB to 3.5 for the PIC16F688 and I was able to program my first diagnostic chip without a hitch. I put the chip in the REN24 and I got the two leds to blink away. When I use MPLAB I don't have a problem. When I go into the Pickit2 software I have to remember to set a VPP option setting and I have to make sure that I use 4.5v for erasing a chip and 3.5v when writing the chip. Also, I did take the fast programming option off as well.

When I do write the program to the chip I notice for a split second that there is a message of "deleting lower level vpp from code" or something very similar to that and then it finalizing and is verified. What I have done it taken an already programed chip and compared it to what I got and I do notice that the code on my chip is slightly shorter. Should I be concerned?


Reply
Page 4 / 4
Share: