Pickit2 problems
 
Notifications
Clear all

Pickit2 problems

16 Posts
8 Users
0 Reactions
22.2 K Views
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

UPDATE: I put a chip in the cradle that was already programmed and was able to read it. I was able to import a hex file, but was still unable to write it to the chip.

I went into the troubleshooting option in the Pickit2 software. The first initial test to determine if I was getting 5v passed without a hitch. The second test for the VPP is what I found interesting. If I tested the VPP right when the test screen came up for it I would get a pass, but if I waited about two seconds and tried it again it would fail and kept failing after that. The VPP was testing at 12V on the initial test and then would drop to 11.4V and drop further and further where it would stay constant around 9.8V. I hooked up the multimeter to it and I kept getting 8.9V myself.

I tried all three available USB ports that I had available on my computer. It was the same story. I even got a "Short" error one time. I'm running this programmer on a Compaq 1.8GHZ EVO 510 SFF.


Reply
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

Would it be possible to tweak the cradle to where I could generate power to that remotely? Should I try to get another programmer as this one has really been nothing but trouble?


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

I would definitely return it. Once you modify it, its yours! Did you upgrade the Firmware as someone else suggested?


Reply
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

I have the latest and greatest firmware and software coursing through the PICKIT2's veins.

I have tried countless times to get a hold of Sure-Electronics and have yet to receive an email from them.


Reply
Posts: 188
(@awhaley)
Estimable Member
Joined: 18 years ago

Hmmm. I've also only used the actual Microchip programmer, because it's not that much more costly.. and I wanted to program new chips, which weren't on the 'supported' list for the clones.

If you have a breadboard or a board with an ICSP header, I would try programming the chip without the carrier board. A return of ox00 can mean just about anything is wrong with the communication... it can mean no power, or no connection on either the clock or data lines, or a VPP problem... I would personally find some way to test the programmer without the carrier board so you know where the problem is...

I'm sure you've checked it already, but I'd check again to make sure you've got the chip in the right place for its pin count and going the right direction... figuring out where in which socket the chip goes can be annoying with some of the ZIF boards out there...

You can read the programming specs for your chip, but 9V is enough VPP for some PICs, and not enough for others... I don't know why you'd be seeing the voltage change between tests... that's a little odd.

Let us know how it turns out!

Art


Reply
Page 3 / 4
Share: