Pic programing prob...
 
Notifications
Clear all

Pic programing problems

13 Posts
5 Users
0 Reactions
5,937 Views
Dave Burrows
Posts: 84
Topic starter
(@dave-burrows)
Estimable Member
Joined: 17 years ago
[#12892]

I've been trying to program a new starting address for 1 of my REN64XC, with a start add of 8 (i have watched all the Wayne J videos and read all the Start add guide). After getting the pickit3 to operate and program the chip, i place it on the board and the LED for channel 1 lights up.
Now thinking i got the start address wrong, i have tried to program it back to standard and channel 1 lights up again,
Is there something obvious that i'm missing here?

Thanks

Dave


12 Replies
Posts: 2214
(@ctmal)
Famed Member
Joined: 19 years ago

If you are using the regular firmware(not the DMX) the pics don't need an address. Each pic strips off it's 8 channels and sends the rest to the next pic in line.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Channel 1 lit up usually indicates a blank PIC so it doesn't sound like the programming worked.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

A good test would be to take a PIC you didn't mess with and move it to the First IC Socket. When you are programming make sure you Verify. I just get in the habit of doing both.


Reply
Dave Burrows
Posts: 84
Topic starter
(@dave-burrows)
Estimable Member
Joined: 17 years ago

Thanks for the quick replys. I'm at work now so i'll try reprogramming tonight.
The start add of 8 is for the second ren 64 that i'm daisy chaining, and yes tried another known good pic and all was well.

Thanks again

Dave


Reply
Page 1 / 3
Share: