Notifications
Clear all
Oct 24, 2011 12:45 pm
I know that when code goes through a PIC with renard code the channels used on that device are "eaten" so 2 devices couldnt use the same channel numbers, is this the same with the DMX code for renard boards?
Stephen
1 Reply
Oct 24, 2011 12:59 pm
soakes94 wrote:I know that when code goes through a PIC with renard code the channels used on that device are "eaten" so 2 devices couldnt use the same channel numbers, is this the same with the DMX code for renard boards?Stephen
yes - Renard/Serial and Renard/DMX code work the same way wrt to that "feature". However with a bit of surgery it is possible to bypass the IN to the OUT and make the the OUT connector a THRU connector. This is the approach I used on the Ren4Flood controller (via jumpers). Another alternative is to use a DMX splitter and set the starting address on the first PIC of each controller.
