how about doing your idea, but using the tool dip they sell? its more rubber and would be easier to apply
I will try something soon. I just bought 100 of the boards from the Electronic Goldmine so I am committed (and my wife thinks I should be committed).
Why not go with the ulta brite leds for strobes 8)
conected to the 595 directly no relays then you can time them with vixen.
I don't think it would have the same blinding flash of a 5 joule plasma arc.
If it were a camera strobe you would not need to turn off the lights. The high output LEDs I have found are for flashlights (torch) and such.
I bought 305,000 uF of 350VAC capacitors (5 x 6100uF) for the power supply. The camera boards are on the way.
Do you have a part number of what you used?
Jeff C
FireGod,
Do you plan on using your HV power supply to charge the onboard caps or are you going to power the strobe tube directly ?
Steve
jcoll549 wrote:Do you have a part number of what you used?Jeff C
I bought all five of them on eBay for $25.00 ($5.00 each). If you bought them from Mouser they would cost $125.00 each (a total of $625.00). I don't have them yet, they are on the way along with a 40 amp bridge rectifier.
I am also getting ten 10 watt 1K resistors. I plan to put 5 in series with two parallel paths for the slow charging circuit. I bought a 40 amp contactor also on eBay for $15 delivered. You can not just plug the capaitors into the 220VAC bridge, it will blow the circuit breaker so you have to get them charged first before bypassing the charge limiting resistors.
Here is what I have in mind:
I will be using the 300VDC power supply to charge the on board cap. I am using an 820 ohm resistor between the 300VDC power suppy and the on board cap to limit the charge rate. Each on board cap will have an 820 ohm resistor. You also have to do this or the strobe would drain the power supply while melting itself down.
If you play around with this stuff, be very very careful. These caps are deadly once they are charged.
Edit: Schematic was revised to show the "as-built" condition 6/28/07
