Two-wire interface
 
Notifications
Clear all

Two-wire interface

13 Posts
9 Users
0 Reactions
8,066 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
[#67]

Does anyone see any significant advantage in coming up with a two-wire, bi-directional scheme for communication with dimming controllers? Something similar to the Dallas one-wire scheme, but adapted for this type of application. It's not clear to me that there is any big advantage in going from a cat-5 wire scheme down to a simple two-wire scheme (maybe like doorbell wire, or perhaps one twisted pair), but I thought that I would ask. I'm noodling around with some ideas here...

--

Phil

DSCN2201

12 Replies
Posts: 229
(@mrplow123)
Reputable Member
Joined: 19 years ago

I don't really see a problem with using cat 5 currently. It has it's advantages, mostly readily available connectors. But one big advantage to a 2 wire system would be cheaper wire. As long as it would not need to be shielded or twisted pair. One kind of wire that comes to mind is 4 conductor phone/alarm wire. It is alot cheaper then cat 5. The main purpose of cat 5 is noise cancelation for data transmission. Since we are not really transmitting data that requires the twisted pair, the wire really is over kill.

So I say if you think you have a solution that uses only a pair of wires, well you sort of already do with your transformer idea, then it is worth exploring.

IMG00058 20121222 2243

Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

If the cabling required for a new design is cheaper than cat 5 then it could have an advantage. If it is less common and more costly cable then there would need to be some other advantage to make up for the extra cost.


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

The two wires that I’ve used in the past, was truly only two wires. Power and ground, where the power line is also used for data communication. If the current needed down the line is low, this can work very well. Its not noise tolerant, so the robustness would need to be added to the protocol.


Reply
kostyun
Posts: 2178
Guest
(@kostyun)
Member
Joined: 20 years ago

One thing to also consider is that the current renard CAN be done on three wires with RS485. A, B and GND.

You even have a spare wire that could be used for zero cross detection.


Reply
Page 1 / 3
Share: