Hi All,
I started my first music sequence show last night and I noticed a few layout issues. This morning I looked over channels and saw a few things that needed tweaking. After I made the changes, saved and tried to run the sequence it refuses to play. It loads into XLights fine but I cannot get it to run. All that happens is the FPS: flickers numbers. I ran Check Sequence and found no errors. I probably need to re-load the sequence onto my FPP but I can't run it first to check things. I also notice that if I start a new sequence everything is cool. It only happens on sequences created before I changed layout settings. Any help would be appreciated.
Running XLights 2017.37 - 64bit
e682
FPP
I'm stressing!!
Thank you if you have ANY suggestions!
Render all. There is a bug in 37 which requires a render on load. Will be fixed in .38 due early next week.
Best to delete you fseq file out of xlights, then render all. It will create a new fseq with all the changes. Just updating the fseq does not update everything. Then upload to your FPP.
Hi, thanks for the responses. I tried to Render All but that didn't fix it. I tried deleting and creating a new fseq and no good. It turns out that Microsoft applied a patch to my audio driver which caused a driver conflict. Once I reinstalled the correct audio driver the sequence played again. I guess without the proper driver the sequence won't play at all!
I'm all good now.
Thanks again!
That's correct. For a multimedia sequence we display the lights according to where the song is up to. That way if the computer is slow the lights skip frames but stay in sync.
