xlights sends out w...
 
Notifications
Clear all

xlights sends out wrong data to pixels.

22 Posts
3 Users
0 Reactions
9,764 Views
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

Oh, I scared everyone.
But it doesn't matter, the project is canceled because there is no more time. Wish everyone a Merry Christmas. Greetings Jörg


Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

Hello Mike, thank you for your feedback. I can try again, maybe something will change.
The orange data cable goes in at the beginning and if I understand it correctly it goes from module to module until I connect the two data cables (blue). From then on the organ ends. Or can also be connected together at the beginning with data cables. IM not sure.

The orange data cable is routed from module to module via the yellow / green cable. Arch on the left, Christmas tree, candy cane, snowflake, star base, star, star, snowflake, star and to the arch on the right.

I haven't paid much attention to the data speed until now. But there could be something to it, when you take a quick look, neither the screen display nor the lights follow. This is the case, for example, with Do They Know lt's Christmas for short periods.
Thank you Mike, I'll report if anything changes. Greetings Jörg


Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

With xlights, only a maximum of 1000 channels can be set. At least with a generic serial. Where do I then enter the missing channels from 875?


Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

I just changed the data. Unfortunately nothing changes about the fact that the fir tree does not shine alone. Other areas always shine with the same number of pixels.

25

26

The following error is entered in the check sequence. From the star with the foot onwards, the models have no controller assignment. But somehow I can't assign them because I can set over 1000 channels.

28

Under the controller settings under Models you can see the modules are missing.
Question: How do I get it that I can assign the missing modules to the Teennsy when I can only enter 1000 channels. Somehow I have to tell xlights that from pixels ?? the second data cable is to be used. And where do I have to connect the second data cable. From the pixel or directly to the beginning of the modules.

27

The three pixels also shine unchanged in white

23

Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

Hello, does anyone have any idea how I could assign the channels over 1000. I have no more ideas how to get it going.
Greetings Jörg


Reply
Page 3 / 5
Share: