xlights sends out w...
 
Notifications
Clear all

xlights sends out wrong data to pixels.

22 Posts
3 Users
0 Reactions
9,760 Views
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

Hi Mike,
I've tried other settings like DMX, but nothing happens.
Thank you very much for your effort, but the lighting is over for this Christmas.
Have a nice christmas


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
jssr wrote:With xlights, only a maximum of 1000 channels can be set. At least with a generic serial. Where do I then enter the missing channels from 875?

ESPixelStick V4 will output up to 3600 channels on the ESP8266 and 9000 channels on the ESP32. WARNING: At the data transfer rates used by most generic serial devices, this amounts to a multi second refresh rate (as in 1 or less frames per second).

At 120Kbps data rates you get the following refresh rate for 1000 channels:

120000 bits per second data transfer rate.
8 bits of data plus two overhead bits = 10 bits per channel
120000 / 10 = 12000 data bytes per second
1000 channels = 12 frames per second

Most of us run our shows at 20fps or 40fps. That makes 1000 channels on a generic serial line a less than good design choice.


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

.39 now supports 4096 channels of generic serial

Sent from my iPhone using Tapatalk


Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

4096 could help me get my 1875 working.
On my laptop he just showed me that there is a new version. Is a very fresh version.
Will test it tomorrow evening. It's almost midnight here now.
In any case, thanks for the info. Will report if it works now.


Reply
Posts: 39
 jssr
Topic starter
(@jssr)
Eminent Member
Joined: 5 years ago

Hello Mike, that was the message I was desperately looking for. It finally works with the channel expansion. Now I can set up the lighting a few days later and hope that no further problems arise.
But I don't want to forget to thank everyone. Without your help and support, I would not have made it.
When everything is set up I'll make a video. Jörg


Reply
Page 4 / 5
Share: