Xlights issue playi...
 
Notifications
Clear all

Xlights issue playing vixen sequences

4 Posts
3 Users
0 Reactions
2,105 Views
DaveJZ
Posts: 974
Topic starter
(@davejz)
Noble Member
Joined: 16 years ago
[#39463]

Trying to get away from using Vixen 3 Scheduler

I've converted a Vixen3 to a vixen 2.1 and added it to my playlist in xlights- I have set up my controllers in Xlights. universe1-6 for e1.31 and 192 renard channels. They all test through xlights test light feature and seem to be ok.

My sequences run ok in vixen3

I've created a playlist in Xlights and added the converted sequence to the playlist. When I try to play the playlist I have no response from my controllers. I notice a huge jump in CPU usage when I press play... and most times It will become unresponsive... it will come out of it and the log will show it is playing the sequence, however there is no blinky. I'm using an AMD 2ghz with 2.25gb ram.. vixen scheduler runs with lags in some sequences and then gives up all together after awhile. Might be pushing the limits of the computer but thats why I wanted to try xlights first

I have the 192 renard channels and 950 pixels spread out on an e682 (1- sets of 50, 2- sets of 50, 3- sets of 50 and 4-sets of 100) The E1.31 was listed as the first controller patched in vixen and listed first in Xlights.

I could only get Xlights to see the e682in unicast. Connected either direct or through a router. Again the lights will function in the Xlight test mode but I get nothing while playing a sequence. I'm guessing its either a conversion issue or a set up issue.

Is there a step by step to set this thing up or is there anyone that can help me. It has been a rough year, the lights are finally up and and I just want to get through this year half way decent so I can decide if we are going to continue doing displays in the future.

Things have changed so much and It's sad to say but for some reason this year I'm just not feeling it... and what was/ is suppose to be fun hasn't been at all this year... Thanks in advance for the help


3 Replies
Posts: 843
(@captainmurdoch)
Prominent Member
Joined: 14 years ago

If you are using xLights v4 then you should just use Vixen3's FPP .fseq export which is also the native file format that xLights v4 now uses. That would skip the intermediate vixen 2.x compatible file.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

by any chance are you not clicking the light button on top that outputs too lights top right side should be lite up when clicked


Reply
DaveJZ
Posts: 974
Topic starter
(@davejz)
Noble Member
Joined: 16 years ago

OK... so it was a couple things... the first was I converted the files to vixen 2 and then to lights... I tested with one sequence.. when I opened it in vixen 2 that's when I realized everything but what wanted to do with the lights was there.. everything was blank!!! Converted it again and all appeared. The other issue was setting up the universes for the e682... one that was correct things seemed better... a little more messing around and my show ran for a few hours on xlights... lot better then vixen 3... thanks for the help..


Reply
Share: