HI I stand corrected. The adruino mega is usb hookup and can use an Ethernet shield to connect. So I guess both will work. My question is will xlights be able to control on/off relays .. not pixel set up just to send a signal to an Arduino set up turning relays on and off.
Thanks very much.. sorry for the confusion. I am still doing more reading on this
Garnet
The short answer is that xlights doesn't provide for relay control. You can export an xlights file to vixen and adjust the relay channels to just on/off though.
For dumb rgb strips, there are some control boards that will work with xlights. DC SSRs or the komby boards are both good options. I'd strongly encourage dimmable control over relays. Any difference in effort is minimal and generally more than made up for when it comes time for sequencing.
I created the "On" effect in xLights so that I could turn my LOR A/C channels on and off since I have a mix of those and RGB channels. Couldn't that be used to control relays? It mainly depends on the interface to the board that controls the relays and how it handles the commands being received.
Hi the set up I saw on youtube is Vixen sends a signal to Arduino .. then it goes to the relay board activating the low voltage signal. The proper arduino software has to been on the pc as well.
Garnet
