Hi I have cut many sheets of corro with my 100 watt laser. You need to use lower power and slow speed. The flat part cuts nice but the ribs need th...
Hi. I have not received any replies on the temp rating. I have found out that the individual circuits have different ratings so some would be ok wit...
Hi sorry about that. This code stuff is all new to me. Thanks very much for your help. I think I found the spot in the sketch were it talks about t...
Hi I have a friend doing the sketch stuff but I will try to add it here. This is the link it is from. supports 8 relay outputs with the attachm...
Well I have the w5100 and the mega 2560 hooked up and sketch is running. Having some trouble seeing how to hook up the 5 relay boards to the mega and...
Hi I finally got my mega 2560, w5100 board and an 8 relay board. Now to hook it up to vixen. Should I use vixen 2 or 3? I have seen pros and cons t...
Ok I got it now. Thanks so much for all your help to everyone. I will post some pictures when it is all done.. that should be by Aug if all goes wel...
Ok I found some pictures of the set up on the net. If I understand this each arduino will have enc28j60 or w5100 board hooked up to it from one cha...
Hi so would I look for a USB network switch ...this part is all new to me. An example of one would be great. Thanks very much Garnet
Hi Barnabybear thanks for the post.. all info is great and this is the other option that I was looking at. The link is tons of help. I may do a com...
Hi keithsw1111. I will be using regular led strings just hundreds of them. How did you parallel the arduinos with a usb hub or port? Thanks for the ...
On the adafruit forum it was suggested to try the atmega 2560 with GPIO port expanders. They can handle 16 channels and 8 can be added to one atmega ...
Hi Lightup. Doing some more reading and searching. It appears that the parallel set will work the best and possible the easiest. Thanks for the hel...
Thanks for the info .. I was doing some more searching and found this link where he daisy chains 4 together.. So I think I have two options now. Will...
