Tree Dazzler is it ...
 
Notifications
Clear all

Tree Dazzler is it hackable ?

63 Posts
19 Users
0 Reactions
35 K Views
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, as a side note. I made a little PCB (2" x 2") that runs 16 channels (5 dumb strips & one channel spare but you don't have to sequence it) and can be daisy chained up to 64 channels. It gets its data via E1.31, gamma correction and PCT fuses for each string. Whilst hacking the original processor would be the way to go this could offer a viable alternative (cut off the wires and solder to this).
You’ll notice it doesn’t look dissimilar to the original board.

Video: https://vimeo.com/161454639

Original thread, it drags on a bit – skip to about post #24:
http://doityourselfchristmas.com/forums/showthread.php?42352-First-time-with-Eagle-and-SMD-all-comments-welcome-before-I-order-these&p=420850#post420850


Reply
Posts: 582
(@jimboha)
Honorable Member
Joined: 12 years ago
Barnabybear wrote:Hi, looks good. Not all props have to be full pixels. If you still have the control board around and don’t think you’ll make any use of it could I have it please? I’ll pay the postage, I’d like see if I can work out what the micro controller is.

Hmm, I may have dumped them. I did not see any real way way to re-work them since they are all SMD and very fine traces. Let me check and see what I can find.

Jimboha


Reply
Posts: 582
(@jimboha)
Honorable Member
Joined: 12 years ago

OK, I've set up the hacked dazzler in the yard/show - here's a daylight photo.

DzzlerInYard 2017 small

Here's a new video on YouTube:

Jim's Super-Dazzler Spiral Tree

Jimboha


Reply
Page 13 / 13
Share: