Should I rewire?
 
Notifications
Clear all

Should I rewire?

7 Posts
5 Users
0 Reactions
6,175 Views
Posts: 66
Topic starter
(@macboy)
Trusted Member
Joined: 7 years ago
[#51636]

I hung the top most window frames today and as I was putting up the middle one I noticed I had wired it different than the others. All of them are wired from the bottom left, clockwise around to the start. The middle one I accidentally wired from the bottom right, clockwise around to the start. I feel like this is going to have to be redone. For example if I want a chase on each window to go clockwise, say five LEDs....the middle window's chase will start at the bottom right, right? So it'll be out of step no matter what I do?

Just looking for confirmation before I climb back up the death ladder (the windows are very very high.....).

RGBW LED bullets, 5V if that matters.


6 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

xlights allows you to designate the starting end on a window frame. You can start it from the other end on that one and your chases will look the same.


Reply
Posts: 66
Topic starter
(@macboy)
Trusted Member
Joined: 7 years ago

Is that only if I set them up using the window model tool?

The start and end are at the same corner. So I'd have to tell XLights that the "start" is like 20 bullets in on the string.

[ one more edit ]

I'm looking at the model in xLights now, with a new window frame model in place. I see how I can specify the starting location - that's great. However, how do I tell it that the starting location differs from the first channel in the model (and how it's physically wired)? And then, while I'm at it here - do I have greater, less or equal control over the pixels if I use a window frame to model it vs using a poly line where I can specify and animate each of the four segments individually?


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I don't know about Xlights but in Vixen you can reverse patch those pixels and they would work like they were normally wired. If you have a controller like the Sandevices 682 or 6804 you can reverse those pixels in the controller settings.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 66
Topic starter
(@macboy)
Trusted Member
Joined: 7 years ago

I've been tinkering with it in xLights but think for the effort really involved I'll just pull the frame down and pop the strings out to redo them. Might as well get it right. It's only two more trips up the ladder and it's not like the hangers are a huge pain to deal with - it's quite easy actually. I just don't like going up that high if I don't have to. Not sure why they make extension ladders so wiggly. hahaha


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago

I would test in software first. When exprimenting with house outline some effects did'nt work right, after switching to polylines they worked, then grouped verticals, and horizontals seperatly. Looks good. Some needed the start box on a different end in software. I have not experimented with windows yet, thats next.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I have a bunch of interesting mutations in my show and all of them have been corrected using configuration (patching) magic. I even rotated my mega tree 20 degrees without moving a wire. With the latest sequencing software and controllers like the Falcon V3 and E682s, unless a node malfunctions, there is very little need to go up on the ladder.


Reply
Share: