This is a question for those who have used nutcracker and did a mega tree with pixels. I am curious how good the resolution is on a picture or video on a tree that would be 50 pixels high and 30 strings wide. The tree will be a 180 degree tree at 4 inches looks like the pixels would be pretty far apart.
Thanks
Terry
i think that it would be sufficient. why not 4 or 5 models
start with your current 30x50. we normally give width first, height second when writing resolution
model1 30x50
model2 45x75
model3 15x25
model4 60x100
model5 100x100
you can switch between models on any effect you have (pictures, movies) and see what it will look like.
this was one of the design goals, you could decide how you wanted to build your rgb device before you ordered parts
Terry,
A few things to keep in mind with images though on a tree, as I understand it, it maps out the tree as a grid to apply the image to it, maybe Sean can confirm that. So, if the tree was square that would be kewl, but it isn't, it goes up into a triangle, so wider spacing at the bottom, closer at the top. So it will "stretch" the image somewhat horizontally, vertical spacing will remain the same but horizontal spacing will close in as it goes up. Any time I have tried to put an image on a tree I try to put it on an area of the tree where the vertical and horizontal spacing are as close as possible, sometimes that is the middle, sometimes lower, all depends on your string spacing and pixel spacing. You almost need to make a few different models and play with it to find a good spot on the tree for it where it maintains the best resolution, if you try to make the image the size of the tree it might not come out very well, but give it a try.
Here are a couple images to help with what I am saying, one is the grid pattern that I believe it applies the image using, the other is the tree pattern. Helps to re-enforce what I am trying to say, you clearly see how the tree spacing changes in the drawing as the strings go up the tree.
yes images will distort on a megatree compared to a matrix. they still look fine as long as they are more simple, smaller color ranges. picture of micky mouse probably good, picture of mona lisa not so good.
just use the preview to see what it is going to look like. the preview and my actual tree were exactly the same.
also experiment with making your images a little bigger than the target tree and scroll the image across.
here is why
u have a 30x50 megatree as an example
u have an image that is 800x600
you can use picture effects auto size option (called "scaled" in the pull down). this will make your image 30x50. Notice if you use "scaled" you cant scroll the image up/down/left/right
OR
you can externally scale the image (i use mspaint)
make it 30x50 lowest resolution for your 800x600
second option make it something like 60x100 and scroll it. You now have doubled the resolution, things that were lost are now visible. downside, you dont see the whole image
play with sizes and see what works on your model

