This is what I would do. Go to the bridge's documentation page (believe Jerry-Rigs posted it earlier) and scroll down to the Config. The E131 Bridge. Read over the section on how to over-ride static IP and change to DHCP (#3). Reboot the bridge and your router will assign the bridge an IP address in your network's range. Now you need to figure out what IP address was assigned to the bridge. Using your Mac, open the program 'Terminal', the name of the computer and the current user will be listed followed by a $ sign. After the $ type in arp -a then hit return. A list of IP addresses for all the devices on your network will be listed, which one is the bridge? Look for an IP address that is followed by @ 00:04:XX......., that should be the IP address for the bridge. You can now type that into your browser and you should be good to go. Once on the bridge's webpage you can change that IP address to a static IP address. Good Luck.
Yes, but he needs to first connect the bridge to his home network
wilky37 wrote:the bridge is plugged straight into the computer and its with a straight ethernet cable not a crossover cable
that is going to be the easiest way, rather than going out and buying a crossover cable. Once it is on his home network, setting a static IP on his PC is simple I can talk him through that or we could connect via teamviewer.
In modern ethernet implementations, you do not need a crossover cable. The metallic line interfaces are dxe (they negotiate and self adjust). The IP address is the key.
hi, have opened terminal on my mac and this is the list that appears? (169.254.121.207) at (incomplete) on en1 [ethernet]
? (192.168.0.1) at a0:21:b7:3:8c:5b on en1 ifscope [ethernet]
? (192.168.0.3) at 0:90:a9:d3:c6:80 on en1 ifscope [ethernet]
? (192.168.0.8) at 68:a8:6d:d6:11:2c on en1 ifscope [ethernet]
? (192.168.0.19) at 0:e:58:e5:6d:9c on en1 ifscope [ethernet]
? (192.168.0.21) at 0:e:58:62:e6:e2 on en1 ifscope [ethernet]
? (192.168.0.255) at (incomplete) on en1 ifscope [ethernet]
haven't a clue what I'm looking at but hope this helps
the 169... address is the port on which the bridge is located. You need to configure that interface to use a 192.168.1.xxx address and then you will be able to talk to the bridge
