help needed
 
Notifications
Clear all

help needed

66 Posts
10 Users
0 Reactions
16.2 K Views
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Yes that helps a lot, we now know what subnet your home network is using. What we need to do now is to get an IP address set on one of your systems that is in the default subnet for the bridge (192.168.1.###) Then either w/ a direct connect or through your home network switch you will be able to communicate w/ the bridge and configure it.


Reply
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

Obe


Reply
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

He can force the bridge to get a DHCP assigned IP address. That will put the device on the same subnet so he can talk to it.

Wilky,
On the bridge, Press and release the "reset" button and immediately press and hold the "Mode" button. After the "WEB" and "DMX" lights flash together twice, release the buttons. Then go back to the MAC and type "arp -a" again. There will be a new IP address listed: 192.168.0.xxx where "xxx" is different from the ones you listed above. That is the address of your bridge.
To get to the configuration for the bridge, put the IP address in the address bar of your browser.
Did it work?

You will want to set a permanent IP address in the configuration of bridge. I suggest 192.168.0.200. After you do that, you won't have to money with the buttons as much any more.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

All Valid Points,

I am just getting started in this hobby and I am only using Renards and AC Mini Lights, so I am not familiar w/ the E1.31 bridges. However, I work everyday supporting customers remotely reconfigure network issues. He has at least a wired router, the MAC is connected to it via Ethernet 1 (en1) and his arp shows 4 other devices, his router is most likely .1, so there are 3 other devices (2 PCs) that are either wired or wireless.

If he can connect his bridge to his router/switch, then on one of his PC (you assume Windows7/Vista for opening a command prompt) then we can set a static IP for his home network and add a 2nd IP in the bridges subnet allowing the PC to be both on his home network and the internet and communicate to the bridge. Then a remote session would allow one of you who do know the bridge assist in setting it up.


Reply
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

I just checked over at the other forum Wilky posted on. AAH over there provided a link to the manual for the bridge. Pages 4,5,6 are very useful.


Reply
Page 8 / 14
Share: