help needed
 
Notifications
Clear all

help needed

66 Posts
10 Users
0 Reactions
16.1 K Views
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

I think I saw the same post on the auschristmaslighting forum. It sounded like the conclusion was there may be a problem with that particular board. If you still need xLights help just reply here and I'll get the notification.


Reply
Posts: 48
Topic starter
(@wilky37)
Trusted Member
Joined: 11 years ago

hi, in answer to the above question , yes we have put the dip switch to position 10 ,and all the test patterns work fine, i have been told that these boards are rubbish and never work, hope this is not the case as i have just ordered more and i have quite a few dumb rgb nodes that i want to use, and no i am unable to connect to the bridge web page , i have tried to reset and followed all the instructions, getting frustrated, just hope its something i have done wrong not that the board is not good, if it is this type of boards rubbish what could i use for dumb rgb nodes i am planning to have singing faces in my display , once again thanks


Reply
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

How are you connecting your computer to the bridge?


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

any of the renard series boards would do a great job. Lets not condem the controller until we get a bit further along. Based on your comment about not being able to access the bridge web page, that is a significant next step in the debugging. Whic bridge are you using? Have you ever gotten the bridge to do anything? and as the other person asked, how is the bridge connected to the network to which the show computer is connected?


Reply
Posts: 672
(@pixelpuppy)
Honorable Member
Joined: 12 years ago

I agree. Don't condemn the controller as "rubbish". I have a few that a very similar and they work quite well for their intended purpose. It is possible you have a bad one but unlikely since the test mode seems fine. The suspect here is the bridge connection, not the DMX controller We have not seen any details on that.


Reply
Page 3 / 14
Share: