hi they are dumb rgb nodes they are not pixels, i am honestly not trying to run pixels with this board, the board is
http://www.aliexpress.com/item/dmx-512-30-channel-27channel-Easy-DMX-LED-controller-decoder-dmx512-decoder-controlador-dmx-console/32255469793.html?
are you able too connect too the bridge web page with your computer
That link is very helpful. Did you try to put it in automatic mode (switch 10 up)? In that mode you should be getting test patterns. Do the test patterns work? If not you may have a power or wiring issue. Are you connected to a 12V supply? It will not work connected to a 5V supply. 5V needs to be wired outside the controller board.
In your picture, all of the switches are turned off. I assume you took the picture after resetting the dip switches. If you look at the product page, they have switches 1 & 10 turned on and the rest turned off. This produces a test pattern.
Your Xlights setup is wrong. You have it set for E1.31 but this board only accepts DMX input. If you do not have one you need to acquire a USB to DMX adapter, than setup your Xlights to drive that.
Sent from my IdeaTabA2109A using Tapatalk
he is using the bridge that is e131 and sends out dmx too his board
pwalstead wrote:Your Xlights setup is wrong. You have it set for E1.31 but this board only accepts DMX input. If you do not have one you need to acquire a USB to DMX adapter, than setup your Xlights to drive that.Sent from my IdeaTabA2109A using Tapatalk
