help needed
 
Notifications
Clear all

help needed

66 Posts
10 Users
0 Reactions
16.1 K Views
Posts: 48
Topic starter
(@wilky37)
Trusted Member
Joined: 11 years ago
[#40925]

hi all i am new to this hobby, i am using xlights to sequence my show i have connected my controller board (i am using dumb rgb board i bought from ail express its a 10 output 30 channel board) i have connected it with a e1.31 bridge. i have set it up in xlights as per the numerous tutorials, with 4 universes 512 channels per universe, problem is i can't get the board to work and make the nodes work, on the first board i have set the dip switch to 1 on all the others off but nothing. i have selected output to light on the sequence tab , I'm stuck, is there a chance something i have bought is not working or am i doing something wrong, i am like i say very new so my set up is most likely the problem any help greatly appreciated
Ian


65 Replies
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Any chance of posting a 'screenshot' of your xlights setup page?


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

a model number for the controllers you are using and a diagram of how you have things connected will help. Also look at using a utility like sacnview to generate e1.31 traffic. this helps determine whether the issu uis with xlights or your hardware configuration


Reply
Posts: 48
Topic starter
(@wilky37)
Trusted Member
Joined: 11 years ago
Untitled
IMG 0024
IMG 0025

here is a couple of pictures, one of the setup page and two of the controller like i say this is the first and have set the dip switch to 1on


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

i assume the pixels are in the picture by accident. the controller will drive dumb rgb strips or super strings. what is the model name for the board? are those ws2801 pixels or are they dumb pixels and are you trying to connect them to this controller?


Reply
Page 1 / 14
Share: