Fan effect problem
 
Notifications
Clear all

Fan effect problem

10 Posts
2 Users
0 Reactions
3,284 Views
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago

Cool, I lowered it to 300 then 200 and finally 100. At 100 it looks good. Thanks for the help. Is there some penalty for having it that low? I'm thinking rendering time or more data through the controller???

Sent from my Moto G (4) using Tapatalk


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

The smaller that number the faster the rendering time. Data doesn't change because you're number of channels is fixed. It just reduces the resolution of the effect on the whole house but it's probably not even that noticeable. I would have thought 200 or 300 should have been fine if you really are using Fan....Pinwheel will have issues earlier than Fan.


Reply
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago

Okay, then I really want to find the biggest number that is acceptable to me then? This is kind of confusing to me since it would seem that I'm increasing resolution to solve the problem, but I think you're saying that I'm decreasing the resolution since rendering time is going to be shorter and not longer. Is there somewhere I can look to read up on all this grid stuff?

Sent from my Moto G (4) using Tapatalk


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

Sorry classes start up again in January. Do a search for "moire pattern" and you might find where I've talked about this before.


Reply
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago

Okay, thanks and I'll do some searching through your posts. Even with what little I'm putting out, those effects will really be nice. They make it clear that this lighting isn't an off the shelf system.

Sent from my Moto G (4) using Tapatalk


Reply
Page 2 / 2
Share: