Fan effect problem
 
Notifications
Clear all

Fan effect problem

10 Posts
2 Users
0 Reactions
3,283 Views
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago
[#43408]

I'm noticing that when I do a fan effect (and pinwheel too I believe) to a whole house group, some pixels aren't lighting on the far areas from the center point as the dark edge passes by, sometimes the pixels that I'm thinking should be lit are flickering too. It's not just at the edge of the transition, if a pixel that should be lit isn't, it never comes on until the effect changes. It's doing this on arches, lines and my custom model chromaflakes.

It shows that in the model preview display and also does it on the actual lights that I have hooked up in the house for testing. It's definitely not the lights or the controller.


9 Replies
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago

Here's a screen shot showing the pinwheel effect breaking up my house outline. The green horizontal lines should be solid, not with little dead spots, the same for red inverted V on the right. I upgraded to the latest release (2016.53) and it's still doing it. I have two of my chroma flakes in the bedroom running the sequence from FPP through a falcon 16 and the fan and pinwheel effects leave dead pixels on the chromaflake that would be at the far left of my scene. It's definitely in the generated sequence. Every other effect seems to work as I expect. When I use those effects on an individual model, there is no issue at all, just with the whole house version. There are no other sequences applied to those individual models.

pinwheelbug

Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

I think I designed it to work with groups as large as 400x400. Is your group set to "Minimal Grid" with a size of 400?


Reply
Posts: 236
Topic starter
(@afremont)
Reputable Member
Joined: 10 years ago

Yes, minimal grid and 400. Is my layout just too wide?

Sent from my Moto G (4) using Tapatalk


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

You could type in a smaller number for the grid size and that would help. I keep meaning to improve that algorithm so that the step size is more dynamic and can shrink as you get further away from center.


Reply
Page 1 / 2
Share: