Expo 2x2 P10 Matrix...
 
Notifications
Clear all

Expo 2x2 P10 Matrix Sequence....

72 Posts
12 Users
0 Reactions
21.3 K Views
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago

Here is my working panel config. Make sure your connections to the between the controller and the panels match your config screen.

2x2 panel config

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
jnealand wrote:Here is my working panel config. Make sure your connections to the between the controller and the panels match your config screen.

Your configuration says feed bottom left, but your panel layout shows top right.


Reply
Posts: 49
(@ametsman)
Trusted Member
Joined: 13 years ago

This is what got it working

Panel3

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
ametsman wrote:This is what got it working

That layout is a mess. Hard to believe it works. Maybe the next sequence won't.

This is what runs a xlight 2X2 layout for me.

CaptureXLTL

Reply
Posts: 49
(@ametsman)
Trusted Member
Joined: 13 years ago

I know it's a mess. Can't figure out for the life of me why it's working. Maybe it's something in the xlights matrix setup.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Ametsman, can you post a picture of your panel back side. I'd like to see the layout and cabling


Reply
Posts: 49
(@ametsman)
Trusted Member
Joined: 13 years ago
panelback

Reply
Posts: 49
(@ametsman)
Trusted Member
Joined: 13 years ago

I'm guessing it's something in the matrix design in xLights.


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

That can't be working right. You have an output specified that doesn't even have a ribbon cable connected to it. You're probably getting data bleed over. xLights is just sending a block of channels it has no idea how you're panel outputs are defined. I just got my 2x2 going 10 minutes ago.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I see it but it's hard to believe


Reply
Page 5 / 8
Share: