Bleed over into oth...
 
Notifications
Clear all

Bleed over into other props

5 Posts
3 Users
0 Reactions
2,279 Views
Posts: 230
Topic starter
(@oldandslow)
Reputable Member
Joined: 16 years ago
[#46117]

I have my P-10 panels running perfectly thanks to the members on this site. My question is when I run a effect on my panel it some times goes into the other props. How do you stop this and do I need to.

I am going to bring all my sequences into xlights from LOR and I have the other props all done (pixels) in LOR. Will this mess up with the bleed over from the p-10 panels?

My over all goal is to import all 192 channels of LED and pixels from LOR into xlights and run from XLIGHTS. I was going to export the xlights and run from LOR but I'm not sure LOR can handle 90,000 channels.

When I set up my model in master view I had the p-10 panels last and mapped my other pixels to match LOR set up.

How would any of you people go about doing what I am going to do? I am open to any suggestions on what to do.

Thanks
John


4 Replies
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

In Layout you can check the box for overlapped channels. Perhaps you have some that are sharing, which isn't good.


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

Run check sequence. It will highlight all your issues.


Reply
Posts: 230
Topic starter
(@oldandslow)
Reputable Member
Joined: 16 years ago
keithsw1111 wrote:Run check sequence. It will highlight all your issues.

I did check and I do have overlapped channels. If I just highlight the other props and hit delete would that take care of the problem. I do not want to mess with my p-10 panel at all.
What would be the best and easiest way to get rid of this problem?


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

It is not possible for me to know what is best for you. I just know that overlapping channels will cause effects on one model to light up the corresponding lights on the other model.


Reply
Share: