Been looking through the threads on here and seeing a lot of people disgruntled with using tomato cages etc for their mini trees.
No uniform shape
Modifiying and rewelding to get a conical shape
GFI faults (forgive me if I got the acronym wrong. I'm an Aussie)
Etc Etc.
Reading tonight it came to me.A simple method to resolve all these issues using a simple piece of Corflute , Coroplast or whatever your locale calls it .
Draw out on your corflute whatever size you require your mini tree to be as below . The off cuts are important so dont try save space by turning one upside down.
Cut half way up and down on your center lines to whatever thickness your corflute is . My scrap piece was 5 mm thick. (Just remember all those balsa models you built as a kid)
Slot them together as below
This is where the off cuts come in, place them in each corner to give your tree more body. Hot glue them in place ( I didnt go past this step as its only a concept)
Top view
Side view
Wrap with lights. I will leave it here as this is not the way I'm going this year. Was simply an idea that popped into my head. 🙂
Hi:
Good idea.
Using diagonal cutters, small slots could be cut into the ribs to hold the wire/lights in place.
This idea could be also be used with thin plywood and painted, but the Coroplast is probably cheaper. Or should I say, lower in cost?
Rather than start a new thread will just tack onto this one.
My newest mini tree design is a 3D RGB corflute tree as below.
Photos in daylight plus plan.
I marked out a 4ft by 3ft piece of corflute using a protractor as below. 15 degrees for each line. Then just measured along each line 2ft and marked out the base then tab lines.
Each piece of corflute makes 2 trees
Below is the cutout scored and with the tabs trimmed ready for assembly.
I then cut a hexagon with slightly smaller edges then my base lengths. As Im using pixels that my have water ingress problems I made a second platform to raise them off the ground. Finished item will be hot glued not taped (still waiting on plugs).
So i can flat store these i drilled holes where the 2 edges meet so I can cable tie them together. Any gap can be touch up with white electrical tape come assembly time.
Insert base, fold tabs over then I inserted some small screws to hold it all together.
I'm pretty happy with the end result 🙂 So just 12 - 20 more to make .
That is very impressive considering the tree has only 6 pixels.
impressive!!
bert-nc


