Hi there,
I am planning a tree for Christmas 2018 and am after some guidance/advice with how many pigtails, power supplies and controllers I will need. I have done a quick basic design for the tree (see attached)
Rough spec as follows:
180 degree tree
Tubular aluminium frame construction
2.5 metres tall
0.50 metres off floor level
1.25 metre diameter at bottom
0.30 metre diameter at top
dc12v ws2811 ip68 Pixels 50 per strand spaced at 50 ish mm intervals
24 strands total, pixels mounted in off the shelf plastic strip
Star on top not sure but maybe 50-100 pixels.
Plan on using vixen software
Thanks
Here is a link to my wiring setup for a 24 strand 50 pixel tree:
Dropbox File (Private or Invalid)
D1-3 is data ports, A1-6 is power inject. It does not show the 270 pixel star, but that runs off another port with power inject every 90 pixels. All running off one HP Server power supply rated at 75 amps.
Drawback is not every string is the same, some wired up, some down, some with power inject. But is working well. Based off Wolfies design.
Nice drawing!!
I have a 16 string 50 bullet pixel tree this year. It is my first year with pixels. I am using two 12v 360W power supplies. You would need 3. I am using two ESPixelsticks over 6 universes (could have been 5). You will need 8, but ESPixelsticks should still work (or another controller). I used pixel mounting strips from Boscoyo at 2" spacing so my tree height is very similar to yours. I used a 50 pixel Bethlehem Star for the topper (from Boscoyo). I used EMT electrical conduit for the frame. Don't forget hardware to affix the strings at top and bottom.
kev wrote:Nice drawing!!I have a 16 string 50 bullet pixel tree this year. It is my first year with pixels. I am using two 12v 360W power supplies. You would need 3. I am using two ESPixelsticks over 6 universes (could have been 5). You will need 8, but ESPixelsticks should still work (or another controller). I used pixel mounting strips from Boscoyo at 2" spacing so my tree height is very similar to yours. I used a 50 pixel Bethlehem Star for the topper (from Boscoyo). I used EMT electrical conduit for the frame. Don't forget hardware to affix the strings at top and bottom.
Curious why you are using 2 PSU's? I just use one 350W PSU on my 850 light mega-tree (10" 180deg 16 strip). My tree pulls ~250 watts at full white which is right in line with the documented .3W per pixel rating.
This is its 2nd year running... now you have me worried 🙂
From what I have read if you are using 12V pixels they draw quite a bit more than .3W/pixel - closer to .6W. I didn't want to mount 2 PSUs on my 800 pixel tree + 90 pixels for the star. I use 8 ports with zig-zag 50 up/down. I run at 60% so I could run a few more props off the same PS. I mounted a 750W HP server PS in my CG-1500. The HP supplies can be found on ebay for < $20 including shipping.
