Storage Ideas
 
Notifications
Clear all

Storage Ideas

14 Posts
11 Users
0 Reactions
5,395 Views
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

Yea, I too liked the hanging idea. But again, no wall space for that. And if hung, you still have to transport them out to the assembly area. This is where the roller tubs will shine, Just pick up one end and roll it out. There you have all the goods for the tree, PSUs, cables and strips. One trip.


Reply
Posts: 192
(@rdj6107)
Estimable Member
Joined: 11 years ago

for all that are hanging and coiling, i am guessing that your mega tree pixel strips are floating when they are installed and not secure to pvc? is this the case? trying decide which route i want to go next year. 6', 7', 8', or 9' foot tree. doing a 180 degree only. and lastly, are you using square nodes or round?? thanks.

sorry to highjack backstagerob


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago

9 strands of 25 pixels each at 2" spacing plus wiring and hardware from my 4' trees fit perfectly in a 5 gallon bucket. I just coil the strips down in them. Doing the same for my megatree strips when I take it down.

20170101 112252

Reply
IaRoadKill
Posts: 586
(@iaroadkill)
Honorable Member
Joined: 12 years ago
rdj6107 wrote:for all that are hanging and coiling, i am guessing that your mega tree pixel strips are floating when they are installed and not secure to pvc? is this the case? trying decide which route i want to go next year. 6', 7', 8', or 9' foot tree. doing a 180 degree only. and lastly, are you using square nodes or round?? thanks.

sorry to highjack backstagerob

I use round pix nodes and no pvc. Works great on 10' tree but 15' and 28' trees droop a little and move around with wind. I'm still looking for an easy solution.:wink:


Reply
Posts: 192
(@rdj6107)
Estimable Member
Joined: 11 years ago
IaRoadKill wrote:I use round pix nodes and no pvc. Works great on 10' tree but 15' and 28' trees droop a little and move around with wind. I'm still looking for an easy solution.:wink:

what topper do you use to hold the strips together??


Reply
Page 2 / 3
Share: