That's what I was about to say haha!
lightingGURU wrote:So you are only transmitting data from the F16 to the strands and the power is coming from the power supply and bypassing the F16?Does this reduce the need to "power inject" since in a way the power is coming straight from the power supply?
Currently my whole setup utilizes power coming through the F16 so this is a new concept for me.
On a string of 100 pixels, you WILL need to power inject. I inject every 25 pixels (Yes I am over engineered). Most others inject every 50 pixels.
My tree data flow is F16-> to the bottom of a leg-> up the leg -> at the top data and ground go to the next leg -> data goes down the next leg -> for me the data ends but you could go up and down again and stay with in the 600 pixels needed for 25ms refresh rates.
Power (V+ and V-) goes from the PSU to the bottom of each leg. Each leg has a 16awg wire the goes up and injects power every 25 pixels.
MartinMueller2003 wrote:On a string of 100 pixels, you WILL need to power inject. I inject every 25 pixels (Yes I am over engineered). Most others inject every 50 pixels.My tree data flow is F16-> to the bottom of a leg-> up the leg -> at the top data and ground go to the next leg -> data goes down the next leg -> for me the data ends but you could go up and down again and stay with in the 600 pixels needed for 25ms refresh rates.
Power (V+ and V-) goes from the PSU to the bottom of each leg. Each leg has a 16awg wire the goes up and injects power every 25 pixels.
Maybe for 5v pixels, but 12v pixels you can easily go well over 100. Especially in a megatree situation where you leads are relatively short, and in this case where they only have 107 pixels, they'll have no problem powering the strings from the bottom of the tree. Even if theyre 20-22 awg pixels.
Hi to all
So if you run it that way what kind of wire connections can you use to water proof them or do you use the water proof 2&3 pin wire connections
