I ran a quick calculation for my 32x107 Mega Tree but am trying to figure out how to power the F16V3 with the correct amount of power supplies.
In the attached calculation if is saying that I'll need at least 4 power supplies if not more.
I'm pushing 33 amps at 65% power so I would have to drop my brightness down to 50% to be under the amperage threshold to be okay.
How do I power my F16V3 off of more than two power supplies?
Thanks for your guys' help.
You Dont. You leave the V+ outputs on the F16V3 "unconnected" and you run V+ from your power supplies to the Strands. I have a similar tree. I drive eight legs from a single power supply. NONE of them get power from the F16. I power the F16 with a higher quality supply that only provides 10A. My tree only uses 4 outputs on the F16 (I only have 16 legs) You can put as many as six legs per F16 output. That means you would get to six outputs. It might be simpler to wire two legs per output for you and use all 16 ports.
So you are only transmitting data from the F16 to the strands and the power is coming from the power supply and bypassing the F16?
Does this reduce the need to "power inject" since in a way the power is coming straight from the power supply?
Currently my whole setup utilizes power coming through the F16 so this is a new concept for me.
Not my image.. but this may help..
![]()
The key is to make sure all the grounds are tied together.
That is Power Injecting, you still need to inject every 50/100 pixels depending on your Voltage.
