Has anyone built a hoop out of steel pipe? I’m looking around at trampoline frames but I’m having trouble finding anything in the 6-7 foot diameter range. Ideally I’d like to secure the hoop to an ASAP pole using cross bars and not have any supports/tie downs attached to the ground from the hoop. The ASAP pole would be the only contact with the ground. Has anyone attempted this? Also, anyone know a shop that might make one? I’m not a welder.
Sent from my iPhone using Tapatalk
You can bend EMT pipe to that diameter with a Pipe Bender (from HD, Lowes). I have bent 1" EMT in to a 10' radius with little problem. Go slow, bending at approx 5-6" increments until you get the size you want. (I started with a line drawn on my shop floor to match up to).
Ok. That seems doable. I’m hoping I can then find hardware to connect to the pole. Maybe chain link fence or trampoline hardware. I’d like to make 4 crossbars that join to the pole like a big “X”.
Sent from my iPhone using Tapatalk
It is not advisable to attach the hoop solely to the ASAP pole if the ASAP is mounted in a Portable Hole . The wind can set up a momentum [rocking motion] and the pole threads can break off in the coupling of the Portable Hole . I know of one instance where this has happened before .
I used the hoop bender for my 6 ft. hoop http://www.buildmyowngreenhouse.com/dy-10-hoop-bender-1-1-1-1.aspx
